JP Magnetic Handset

Each handset consist of the following elements: 
- Handset type: Receiver with Magnet and electronic-based Carbon Transmitter/Microphone
- Handset handle and cap material: ABS plastic
- Wiring: Four 24 gauge Teflon insulated wires (2 for receiver, 2 for transmitter), with single modular plug (Optional 4 spade conductors)
- Armored Cord Assembly.: 304 Stainless Steel, Interlock style. Inside Diameter, 0.250", 6.350mm. Outside Diameter, 0.329", 8.357mm. Linear Pull Test Load, 1000 lbs., 454 kg 
- Includes steel lanyard which is anchored to handset handle. Steel lanyard has a pull test load of approx. 1000 lbs, 454 kgs. 
- Color: Black 
- Other Components: lanyard block retainer; anti-rotation wedge; transmitter holder; blue rubber grommet to seal handset/cord connection 

4-pin modular connectors are supplied with most handsets at no additional cost, while supplies last. Certain handset variants which require modular connectors may require an upcharge.

Standard Receiver: 
- DC Resistance at 20 degress C : 145 ± 15 ohm 
- Frequency Response Range: 300-3400 Hz 
- Sensitivity: 100 ± 2 dB at 60mv 
- Impedance: 150 ± 30 ohm at 1 KHz 


Microphone Options: 
Standard Carbon Transmitter (Default) 
DT-05 Dynamic V1 (Optional) 
IDR-35 Dynamic V2 (Optional) 
EMS-94 Electret (Optional)
Noise-Canceling, Electret or Carbon-compatible (Optional)

Custom colors, cord lengths, microphones and wire terminal/plugs are available depending on details and volume. Call 1-800-884-4835 or fill out the contact us form to inquire about custom handsets or volume quotes.
Handset caps are sealed with high-strength epoxy adhesive prior to shipping, unless otherwise requested.